Outdoor evenings shouldn’t get cut short just because the air turns cool. The headache is keeping warmth steady when the weather shifts—because a heater that gives up in wind or rain does more than leave you cold. It kills the mood, forces everyone inside, and makes you burn extra energy trying to make up for it. We built this IP65 waterproof electric patio heater to keep comfort consistent and clean, whether you’re running a deck dinner or sitting out under the stars. What’s actually under the hood This unit runs on an infrared heating element, so you get radiant warmth that hits people and surfaces directly—no waiting around for the air to heat up. The IP65 rating means the housing and internals are sealed against water jets and dust, so rain, spray, and wind won’t shut it down. A tough quartz tube protects the element. Plug it into a standard 13A outlet using the 1.8m cord, and you’re set. A built-in thermostat keeps the feel even, and tip-over protection cuts power if the heater gets knocked out of place. Why this approach makes sense Modern outdoor living wants heat that just works—quietly, cleanly, and without drama. Infrared warmth feels natural, the kind that settles into shoulders and hands, helping circulation and easing muscles after a long day outside. Because the heat goes where you need it, you don’t have to over-run the system to keep a covered patio, balcony, or garden seating comfortable. And with the IP65 seal, you can use it through changing conditions without checking the forecast every five minutes or babysitting the equipment. Practical setup and use Point the heater so the infrared path hits the seating area directly, with nothing in the way. IP65 is built for outdoor use, but this isn’t meant for full submersion or high-pressure washing—keep direct jets off the controls and connections. It performs best in sheltered to moderately exposed spots; in very strong wind, heat disperses faster, so consider a wind screen or step up to a higher output model. Plug into a weatherproof outlet on a dedicated circuit, and keep the cord out of foot traffic. That’s how you keep it safe and get the most life out of it.